Adjust pH of latex to 8.0 with 10% ammonium hydroxide before other additions. Add ingredients in order listed. Use the following procedure for dip-molding supported gloves: Dip a ceramic form into a coagulant bath of calcium nitrate at 30% solids in methyl alcohol and slowly withdraw the form. Let the form dry at room temperature until the alcohol evaporates. Gloss will disappear. Slowly dip the ceramic form. Immerse the latex-coated form in the coagulant bath for 10 s. Place the coagulated latex coated form in a leach bath of water at 90-100'F for 1 hr. Dry the glove on the form for 2 hr at 150'F, then cure for 10 min at 300'F. For dip-molding supported gloves, use the following procedure: Place a cotton fabric glove blank on a form. Remove surface fuzz by exposing the blank to a flame from a bunsen burner. Dip the form and cotton blank briefly into the latex dipping compound, covering only the finger area. Withdraw the form and dry for 20 s at room temperature. Dip the entire glove in th
地址：山东省烟台市开发区南昌大街48号
