配方类型:

COATINGS

配方说明:

Powder Coating Compounds

配方组成:

"Geon" Dispersion Drying Resin/3
FORMULA No.4 (General Purpose Coating-Expanded
DIDP Plasticizer/30-50
(Leave out "Geon" Dispersion Drying Resin for Electrostatic Spray)
Pigment Dispersion (color desired)/1-10
"Geon" 140 Series Vynyl Resin/100
"Noda" Plasticizer/40
"Admex" 746 Plasticizer/Stabilizer/5
Thermolite 31 Stabilizer/4
Pigment Dispersion (color desired)/2-10
"Geon" Dispersion Drying Resin/5
"Paraplex" G-62 Plasticizer/Stabilizer/10
Calcium Carbonate Filler/0-10
"Geon" 140 Series Vynyl Resin/100
"Geon" 140 Series Vinyl Resin/100
DOP Plasticizer/40
"Santicizer" 160 Plasticizer/30
"Paraplex" G-62 Plasticizer/Stabilizer/5
"Geon" 140 Series Vynyl Resin/100
"Kempore" SD-125 Blowing Agent/4
"Ferro" 5019 Stabilizer/3
"Geon" Dispersion Drying Resin/5
DIDP Plasticizer/30
"Geon" Dispersion Drying Resin/3-5
"Paraplex" G-62 Plasticizer/Stabilizer/10
"Synpron" 790 Stabilizer/5-8
"Mark"

配制方法:

If mixer is equipped with a steam jacket, preheat jacket to approximately 200'F (93'C). Charge all "Geon" 140 resin to mixer. Mix at high speed until temperature of mix is 140-150'F (60-65'C). Add liquid blend (masterbatch plasticizers, liquid stabilizers, and pigment dispersions,if possible.) Mix well until dry point is reached. this should occur from 170-220'F (76-104'C). Polymeric plasticizers should be preheated to 120-135'F (48-57'C) before adding. Add other ingredients, such as fillers, lubricants, dry pigments, etc. Hold out drying resin.
Drop mix from high-intensity mixer to a cooling mixer, such as a ribbon blender or other low-intensity, tumbling-type mixer. Drop temperature may depend on the plasticizer system; approximate temperature ranges are: 170-190'F (76-87'C) for monomeric plasticizers 190-220'F (87-104'C) for polymeric plasticizers Reduce mix temperature to 125'F (51'C) or lower. Add drying resin and thoroughly disperse. Due to the inadequate mixing action of some mixers used for cooli