配方类型:

COATINGS

配方说明:

Clear Hardboard Coating

配方组成:

Triisopropanolamine/6.3
"Hycar" 2600X256/598.3
Citric Acid/10.1
Add the ingredients in order shown under moderate agitation. Add
citric acid catalyst just prior to use. If an increase in viscosity is
desired "Cellosize" QP-09 should be used prior to catalyst addition. If
a defoamer is needed, it should be mixed with part of the butyl
"Cellosolve" at about a 20% level prior to the formulation.
Cure a 2-mil wet coating by achieving a board surface temperature of
130-140'C (265-285'F).
Formula No.3 (Pigmented
Butyl "Cellosolve" Acetate/37.6
"Geon" 660X1/612.7
"Hycar" 2600X256/376.4
Triisopropanolamine/21.9
"Pluronic" L-62/9.0
"Nopcosant" L/23.3
M-Pyrol/29.2
"Ti Pure" R-960/131.0
Barytes/328.0
"Atomite"/328.0
"Cellosize" QP-09/29.0
"Cymel" 373/237.7
Citric Acid/75.3
Butyl "Cellosolve"/70.8
"Hycar" 2600X237/376.4
"Pluronic" L-62/10.1

配制方法:

First add the TIPA, "Pluronic" L-62, "Nopcosant" L and M-pyrol to "Geon" 660X1 under moderate agitation. Increase the agitation speed and add the "Ti pure" R-960, Barytes, and "Atomite." Then, at a reduced speed adjust the viscosity with "Cellosize" QP-09.
This 73.5% T.S. filler compound can be applied by reverse roll coating.
Once dried, this coating can be sanded to refine the board surface prior to subsequent coatings.