Charge the mixing vessel with the water of dilution. With good agitation, slowly add the components in the order listed. Continue stirring for one-half hour. Adjust the pH to 7.5-8.5, if necessary, with 28% ammonium hydroxide. Surface Preparation: The floor surface should be thoroughly cleaned and rinsed. Sufficient care should be taken to remove oily type soils. Acid etching is not recommended. Application: Two coats are recommended. Allow up to 1 h between coats, depending on solids and drying conditions. Coverage: Approximately 500 ft^2/gal, and up to 1500 ft^2/gal for the second coat, depending on the conditions of the substrate.
地址：山东省烟台市开发区南昌大街48号
